Videor Technical ENC-1001L Instrucciones de operaciones

1Control software for eneo and Axis network camerasOperating Instructions

10If information is to be sent to an e-mail server following the activation of the alarm, these functions can be activated accordingly:Select e-mail f

11Operate the loudspeaker and volume of the Axis devices.Live image is switched off if Autoconnect is not selected.Stop the live stream in order to b

12Start „Trace route” command„Ping” commandThe „ping” command is used to check the availability of a device in the network. The response comes back w

13The Zelaris AS can be configured in two different operating modes. These are:• Single-licence application (server)• Multiple-licence application (c

14Up to 16 clients can be registered in the server application #76011. These can be set up as both internal and external LAN clients. A connection via

15A password is always needed in order to configure or close the Zelaris AS or the Zelaris AC. When the programme is delivered the user name is „admin

16In the Appendix you will find instructions on the setup (installation) of the Zelaris AS / AC.Step 1Select folder for programme installation.Start se

17Step 2Select programme name for start menu.Step 3Step 4Status display during programme installationTerminate installationThe completion of the insta

18Instructions on setting the configuration of the network camera or video serverAXISCreate an event server for FTP events

19

2Contents 1. General Description...

20Define destination for alarm images.Define the total length of the recording. 0 seconds = 1 imageConfirm inputDefine number of images before and after

21When the FTP protocol is being used, enter the address, port, user ID, password, and memory path.Confirm inputActivate image trans-fer for FTP events

22When the eMail pro-tocol is being used, enter the server address and eMail address.Confirm input

23Model ZELARIS_AC S ZELARIS_AC CDescription Control software for network cameras from eneo and AxisClient software for Zelaris_AC SEDP No. 76011 7601

24WEEE (Waste Electrical & Electronic Equipment)Correct Disposal of This Product(Applicable in the European Union and other European countries wit

31. General DescriptionZelaris AS is a programme for use in the field of access control.The combination of eneo network cameras and/or AXIS components

42. PresentationAs can be seen from the foregoing, various different formats and compression procedures can be displayed with the Zelaris AS:• MJPE

5Activate the „Shell” func-tion in order to call up another provider’s software.Activate sounds when certain events occur.4. DescriptionThe Zelaris A

6Enter user ID and passwordSelect the drive or file and sub-folderSMTPEnter user ID and passwordSelect the drive or file and sub-folderFTPThe protocols

7Give a name to the log file.Give a name to the back-up file.Define the maximum number of entries in the log file (between 100 and 32,000)Select language

8If an event is triggered, the connection to the network cameras and/or video server is created immediately. The positi-on of the video image display

9Enter the IP Address of the PDA and the port number to be usedDetermine directory for the alarm imagesSpecify values for network timeout and packet s